Need to keep the sun off your face without the full coverage of a hat? The SPIbeams™ LED Visor is perfect for the transition from day to night. This visor is comfortable and easy to wear. Equipped with multiple LED lights, the SPIbeams™ LED Visor illuminates the world in front of you, while keeping you safe from what is behind you.
This Visor is great alternative to a headlamp! With lights fanning the path in front of you, you will never miss what may be ahead on the trail, city, beach, or wherever you may be! Multiple LED lights on the front and back of the hat ensure that you are able to see and be seen regardless of how dark it may get.
To activate: The Power Pack is located on the left side of the head-wear lining.Powering Front LEDs: On/off located on the underside of the brim.Powering Rear LEDs: Gently press Velcro Straps until you hear a click to switch through Flash Mode, Constant Mode, or to turn OFF.Reminder! After removing head-wear: Turn off to preserve battery life by turning off the Power Pack.First Time Wear: Battery saver tab located on back of hat. Separate the Velcro strap at the rear. On the side which contains the LED circuit, carefully open the pouch, locate the battery saver tab and gently pull free to active the battery.This is HAND-WASHABLE!Care Instructions 1 Remove the two batteries from the Power Pack, located inside of the headgear liner, by unscrewing the two small Phillips screws located closest to the semi-circle. Gently pry open the battery compartment by lifting the tab and remove the two CR2032 batteries. Reinstall the screws for safekeeping. 2 Remove the rear LED assembly located inside the Velcro strap. Place the assembly in a safe place until it can be reinstalled. The rear LED assembly contains one battery. 3 Hand-wash in mild soap and water solution. Do not allow the Power Pack housing to become submerged in water. 4 Allow headgear to air dry thoroughly. Do not dry in the dryer or with forced heat as this may damage the electronics. 5 Once dry, replace the batteries. Take note of the polarity marking (+/-) on the case. Replace the LED assembly in the rear strap.